Release notes for VS100RX, VS100TX firmware

Copyright (c) 2004-2017, Lightware

0.30.06

Released: 2013-08-23

New feature

  • Initial revision.

    • 1.30.36-2

    Released: 2013-08-23

    New feature

  • Serial Interface during LPPF1/2: we enable the use of RS-232 (PDIF channel 0) on low power mode with the maximum baud rate of 9.6 Kbps.

    • Known bug

  • The following formats don’t work with DVI + HDCP:
    + CVT1250D
    + HWP1070
    + SNY1072
    + DMT1070
    + CVT1760H
    + IBM1043

    • Bugfix

  • Improved DSP algorithm for better immunity resistance.
  • Solved some interoperability issues related to the following displays (fine tuned the timing on DDC lines):
    + TOSHIBA, 40CL20S
    + CHIMEI, 402L7000
    + BENQ, TL-462
  • Fixed a bug in the wake-up sequence to allow low power mode link after power up.
  • Improved the Ethernet link setup during low power mode. In previous versions we observed some instability.
  • FIX wake up issue with PC monitors improved interoperability with PC monitors.
  • Standby Mode: we improved the condition of entering/exiting low power mode with HDBase-T firmware.
    Entering low power mode:
    + No TMDS clock for > 5 seconds OR
    + HDBaseT Link is down OR
    + WAKEUP_IN pin is low
    Entering low power mode:
    + No TMDS clock for > 5 seconds OR
    + HDBaseT Link is down OR
    + WAKEUP_IN pin is low
    Exit low power mode:
    + TMDS clock is detected AND
    + There is HDBaseT Link
  • Improved DVI support with HDCP.

    • 1.30.52-0

    Released: 2013-08-23

    Bugfix

  • Rx sense reflection fix.
  • Bug fixing - DVI detection
    + DVI false detection.
  • Improved PDIF channels (RS-232 and IR) signal integrity.
    + The PDIF out channel randomly generated a pulse of ~4ns. This pulse interfered with some IR transmitters/receivers.